TM 9-2320-361-20 14-6. EXHAUST TUBE REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: APPLICABLE MODELS EQUIPMENT CONDITION All Parking brake set (TM 9-2320-361-10). MATERIALS/PARTS GENERAL SAFETY INSTRUCTIONS Cotter pin Do not touch hot exhaust system components with Locknut bare hands. REFERENCES (TM) TM 9-2320-361-10 TM 9-2320-361-20P WARNING Do not touch hot exhaust system components with bare hands; injury to personnel will result. 1. Remove cotter pin (2) and exhaust tube (7) from personnel heater elbow (1). Discard cotter pin (2). 2. Remove two nuts (5), screws (3), clamps (4), and exhaust tube (7) from left front fender (6). 3. Remove locknut (8), screw (10), clamp (9), and exhaust tube (7) from splash shield (11). Discard locknut (8). 4. Remove exhaust tube (7) from vehicle. b. Installation 1. Install exhaust tube (7) on personnel heater elbow (1) with new cotter pin (2) through elbow (1) and tube (7). 2. Install exhaust tube (7) on left front fender (6) with two clamps (4), screws (3), and nuts (5). 3. Install exhaust tube (7) to splash shield (11) with clamp (9), screw (10), and new locknut (8). 14-8