TM9-2320-361-10 2-32. OPERATION OF EARTH BORING AND POLESETTING MAINTENANCE TRUCKS (Contd) (9) To stop winch from turning, depress clutch pedal (5), and release accelerator pedal (8). (10) Move power divider control lever (7) to NEUTRAL and release clutch pedal (5). WARNING Do not pull back on winch control lever during hoisting operations, or load may drop and cause injury or death to personnel. (11) If load is attached to cable (2); (a) Depress clutch pedal (5). (b) Place power divider control lever (7) in REAR WINCH REV. (c) Release clutch pedal (5), lower load and remove cable (2). (12) Lower derrick (3) if raised (refer to c. of this para.) and remove cable (2) from sheave (1) (refer to h. of this para.). (13) Depress clutch pedal (5), place power divider control lever (7) in REAR WINCH FWD, and slowly release clutch pedal (5) to wind in cable (2). (14) Place rear winch control lever (4) in neutral, and secure. (15) Place transmission gearshift lever (6) in “N” (neutral) position and disengage transfer power takeoff lever (9). e. Installing Augers. (1) To install 9-inch, 12-inch, and 16-inch augers (13): (a) Lift locking handle (10), remove holding pin (12), and lift auger (13) from holder (11). 2-165