TM 9-2320-361-10 2-19. USING SLAVE RECEPTACLE TO START ENGINE a. Position right side of slaving (recharging) vehicle to right side of disabled vehicle. b. Shutoff slaving vehicle engine. CAUTION When slaving, always connect slave cable to disabled vehicle first Damage to batteries or cable may result from improperly connecting cable. NOTE Make sure electrical switches on both vehicles are in OFF position. c. Remove cover (2) from slave receptacle (3) and connect slave cable (1) to slave receptacle (3) on disabled vehicle. Repeat procedure on slaving vehicle. d. Start slaving vehicle engine and set idle speed at 1000-1100 rpm. e. Start slaved vehicle engine. f. After engine starts and is running smoothly, disconnect slave cable (1) from both vehicles. g. Put covers (2) back on receptacles (3). h. Clean and stow slave cable (1). i. Observe battery/generator indicator (4) on slaved vehicle. If indicator (4) does not reach green area, notify maintenance personnel. 2-20. OPERATION OF VEHICLE SERVICE LIGHTS Select and set light switch for lighting required. See following chart for switch positions. WARNING When hazard warning light.detergency flashers are in use, they override brake lights/stop lamp operation. Therefore, when driving with hazard warning lights/ emergency flashers operating, be prepared to use hand signals to indicate a stop. Failure to do so may result in injury or death to personnel. 2-88