TM 9-2320-209-34P TM 9-2920-243-34 TM 9-2990-201-45 TM 9-2520-246-34 TM 9-2520-246-34P TM 9-2520-246-34P TM 9-8023-6 TM 9-8617 TM 9-8637 DS and GS Maintenance Manual (Including Repair Parts and Special Tools List): Starter, Engine, Electrical, Leece-Neville Model GS and Depot Maintenance Manual, Turbocharged Engine (Including Repair Parts and Special Tool Lists) DS, GS and Depot Maintenance Manual for Transmissions, Transfers and Power Takeoffs DS and GS Maintenance Repair Parts and Special Tool Lists for Transmissions, Transfers and Power Takeoffs DS and GS Maintenance Repair Parts List (Including Depot Maintenance Allowances): Winch Assembly and with Cable Level Winch Assembly Ordnance Maintenance Winches, Power Takeoffs, Power Divider and Hydraulic Equip- ment Electrical Equipment 5. How to Locate Repair Parts. a. When National Stock Number or Part Number is Unknown: (1) First. Using the table of contents, determine the functional group within which the repair part belongs. This is necessary since illustrations are prepared for functional groups, and listings are divided into the same groups, (2) Second. Find the illustration covering the functional group to which the repair part belongs. (3) Third. Identify the repair part on the illustration and note the illustration figure and item number of the repair part. (4) Fourth. Using the Repair Parts Listing, find the figure and item number noted on the illustration. b. When National Stock Number or Part Number is Known. (1). First. Using the Index of National Stock Numbers and Part Numbers, find the pertinent National stock number or part number. This index is in ascending NSN sequence followed by a list of part numbers in ascending alphanumeric sequence, cross- -referenced to the illustration figure number and item number. (2) Second. After finding the figure and item number, locate the figure and item number in the repair parts list. 6. Abbreviations. Abbreviation AWG br cd id in. NI No. od s syn-ru thd thk w W/ W/O zn zn-pltd 7. Recommendation Improvements, Explanation American wire gage brass cadmium inside diameter inch not illustrated number outside diameter steel synthetic rubber thread thick wide with without zinc zinc plated for Maintenance Publications You can help improve this manual by calling attention to errors and by recommending improvements and stating your reasons for the recommendations. Your letter or DA Form 2028, Recommended Changes to Publications, should be mailed directly to Commander, U.S. Army Tank-Automotive Materiel Readiness Command, ATTN: DRSTA-MB, Warren, Michigan 48090. A reply will be furnished directly to you, x Change 1