TM 9-2320-209-34-2-3 e. Disassembly, Inspection, Repair, Assembly, and Test of Fuel Control Valve. FRAME 1 1. 2. 3. 4. 5. 6. CAUTION Do not dip fuel control valve ing solvent. Electrical parts by doing so. (1) in dry clean- may be damaged Wipe fuel control valve (1) clean with a clean cloth dipped in dry cleaning solvent, wipe fuel control valve dry. Check that fuel control valve (1) has no cracked or broken parts. If cracks or breaks are found, do step 6. Check that electrical leads (2, 3, 4, 5, 6, and 7) have no broken or frayed insulation or damaged connectors on ends. If any electrical leads or connectors are damaged, do step 6. Using ohmmeter, check continuity through heater by placing one ohmmeter lead on terminal (8) and other ohmmeter lead on terminal (9). Circuit should be closed. If circuit is open, do step 6. If fuel control valve (1) passes tests, go to frame 2. If you must get new fuel control valve, do step 6. NOTE Electrical leads (2 and 7) must be used on new fuel control valve (1). Unscrew and take off nut (10). Take off electrical lead (2) and slide off electrical lead (7). Get new fuel control valve (1). END OF TASK 21-79