TM 9-2320-209-34-2-3 (6) Motor resistor, electrical leads, and connector. FRAME 1 1. 2. 3. 4. 5. 6. 7. WARNING Dry cleaning solvent is flammable. DO not use near an open flame. Keep a fire extinguisher nearby when sol- vent is used. Use only in well-ventilated places. Fail- ure to do this may result in injury to personnel and damage to equipment. Wipe bracket (1) with electrical leads (2,3, 4, and 5) with cloth dipped in dry cleaning solvent. Wipe bracket and electrical leads dry. Inspect five electrical leads (2) for damaged insulation and connectors. Go to frame 2 if leads are bad. Check continuity through electrical leads (2) by using an ohmmeter. Place one ohmmeter lead on end of electrical lead, the other ohmmeter lead on end of electrical lead’s pin. Go to frame 2 if an open circuit is found. Inspect electrical leads (3, 4, and 5) for damaged insulation and connectors. Get new leads if leads are bad. Check continuity through electrical leads (3, 4, and 5) by placing ohmmeter leads on each end of electrical lead. Get new lead if circuit is open. Inspect terminal strip (7) and diode holder (8) for cracks and damaged threads. Go to frame 2 if any are found. Check motor resistor by placing ohmmeter leads on outer terminals (9 and 10) of terminal strip (7). Go to frame 2 if circuit is open. END OF TASK 21-45