TM 9-2320-209-34-2-3 FRAME 7 NOTE Put gasket (1), orifice plate plate (4) exactly as shown. assembly (5) on fuel control 1. Put new gasket (1), orifice plate (2), 2. Put orifice plate and gasket assembly (2), and gasket (3) on cover Put orifice plate and gasket valve (6) exactly as shown. and new gasket (3) on cover plate (4). (5) on fuel control valve body (6). 3. Put thermostat (7) and clamp (8) on orifice plate and gasket assembly (5). 4. Screw in three screws (9) finger tight. Tighten three screws evenly, tightening each one a little at a time. 5. Slide two electrical leads (10) on terminals of thermostat (7). 6. Do frame 2 again if fuel control valve did not pass fuel flow test. If fuel control valve still does not pass fuel flow test, get new fuel control valve. END OF TASK 21-44