TM 9-2320-209-34-2-3 FRAME 2 1. Put three spacers (1) on bosses on blower motor (2). 2. Put blower plate (3) on spacers (1). Be sure grommetted hole (4) is near blower motor electrical lead (5). 3. Screw in and tighten three screws with starwashers (6). 4. Put on blower wheel (7) so top of hub (8) is flush with motor shaft (9). Be sure setscrew (10) is opposite flat on motor shaft (9). Tighten setscrew (10). 5. Put electrical lead (5) through grommetted hole (4). GO TO FRAME 3 21-32