TM 9-2320-209-34-2-3 CHAPTER 19 BUMPER AND GUARDS GROUP MAINTENANCE Section I. SCOPE 19-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance pro- cedures for the bumper, brackets, guards, and protective devices for which there are authorized corrective maintenance tasks at the direct and general support maintenance levels. 19-2. EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective maintenance is authorized at the direct and general support maintenance levels are covered in this chapter. Section II. BUMPER, BRACKETS, GUARDS, AND PROTECTIVE DEVICES 19-3. FRONT BUMPER REINFORCING MENT (ALL TRUCKS WITHOUT TOOLS: No special tools required GUSSETS REMOVAL, REPAIR, AND REPLACE- FRONT WINCH). SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Rags PERSONNEL: Two EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Remove brush guard. Refer to para 19-5. (2) Remove two lifting shackles and lifting shackle brackets. Refer to TM 9-2320-209-20. 19-1