TM 9-2320-209-34-2-3 Section III. POWER TAKEOFF ASSEMBLY 18-13. TRANSMISSION FRONT WINCH POWER TAKEOFF REMOVAL AND REPLACEMENT. NOTE This task is the same for double output power takeoffs and single output power takeoffs. This task is shown for the single output power takeoff. TOOLS: No special tools required SUPPLIES: Transmission fluid, MIL-L-2105 Case and cover gasket PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) If working on truck M342A2, remove hydraulic hoist control linkage assembly. Refer to TM 9-2320-209-20. (2) If working on truck with front winch, remove front winch control linkage assembly. Refer to Transmission Power Takeoff Shift Linkage Removal and Replacement, TM 9-2320-209-20. (3) Drain transmission fluid. Refer to LO 9-2320-209-12/1. (4) If working on truck with front winch, remove front winch propeller shaft. Refer to TM 9-2320-209-20. (5) If working on truck M342A2, remove hydraulic hoist pump propeller shaft. Refer to TM 9-2320-209-20. CAUTION Keep dirt out of transmission and power takeoff when doing this task. Dirt can cause damage to equipment. 18-274