TM 9-2320-209-34-2-3 FRAME 17 1. Move shifter rod (1) until detent (2) in shifter fork (3) goes into rear winch forward position (4) in shifter shaft (5). Sliding gear (6) should mesh fully with forward speed gear (7) when input shaft (8) is turned. 2. If sliding gear (6) is not meshed fully with forward speed gear (7), move shifter shaft (5) with screwdriver until it is. 3. Check that sliding gear (6) does not mesh with any other gears in neutral position. Refer to frame 15. 4. Check that sliding gear (6) meshes fully with reverse idler gear in the rear winch reverse position. If gear does not mesh fully, go back to frame 16. GO TO FRAME 18 18-266