TM 9-2320-209-34-2-3 FRAME 16 1. Move shifter rod (1) until detent (2) in shifter fork (3) goes into rear winch reverse position (4) in shifter shaft (5). Sliding gear (6) should mesh fully with reverse idler gear (7) when input shaft (8) is turned. 2. If sliding gear (6) does not mesh fully with reverse idler gear (7), move shifter shaft (5) until gears are meshed fully. 3. Check that sliding gear (6) does not mesh with other gears in neutral position. If gear does not mesh, go back to frame 15. GO TO FRAME 17 18-265