TM 9-2320-209-34-2-3 FRAME 13 1. If oil seal (1) was taken out of bearing cap (2), press in new seal. Make sure that lip on seal faces inside bearing cap (2) and that seal casing is flush with outer end of cap. 2. Put shims (3) on bearing cap (2) as noted. 3. Put bearing cap (2) with oil seal (1) and shims (3) on housing (4). Put in four capscrews and washers (5). 4. Put bearing sleeve (6) on shaft (7) and seat it against bearing in housing (4). 5. Put flange (8) on shaft (7). Put on nut (9) and washer (10). GO TO FRAME 14 18-262