TM 9-2320-209-34-2-3 FRAME 10 1. Put shaft assembly (1) through opening in housing (2) until bearing (3) is seated against inside shoulder of housing. 2. If oil seal (4) was taken out, press new seal into bearing cap (5). Be sure seal lip faces toward housing side of cap. 3. Put shims (6) on bearing cap (5) as noted. 4. Put bearing cap (5) with oil seal (4) and shims (6) on housing (2). Put in four capscrews (7) and washers (8). 5. Put sleeve (9) on shaft assembly (1) through oil seal (4) until it touches bearing (10). GO TO FRAME 11 18-259