TM 9-2320-209-34-2-3 FRAME 7 1. Put threaded end of shifter rod (1) through housing (2). 2. Put nut (3) and washer (4) on shifter rod (1). 3. Thread shifter rod (1) into side of shifter fork (5). 4. Soak packing (6) with oil. Put packing over shifter rod (1) and seat it in housing (2). 5. Put packing plate (7) in place on housing (2) and put in four capscrews and washers (8). 6. Move end of shifter shaft (9) out from packing plate (7) to distance noted. Make sure slot in shaft is positioned as noted. 7. Put on nut (10) on end of shifter shaft (9). 8. Move shifting rod (1) in shifter fork (5) out from packing plate (7) to distance noted. 9. Tighten nut (3) with washer (4) on shifter rod (1) against shifter fork (5). GO TO FRAME 8 18-256