TM 9-2320-209-34-2-3 FRAME 2 1. Put bearing (1) on shaft (2) with bearing against gear (3). 2. Put bearing cap (4) on housing (5). Put in four capscrews and washers (6). NOTE Lip of seal (7) must face in toward housing (5) and casing must be flush with outside of bearing cap (8). 3. If oil seal (7) was taken out, put in new seal. 4. Put bearing cap (8) with seal (7) and shims (9) as noted on housing (5). Put in four capscrews and washers (10). GO TO FRAME 3 18-251