TM 9-2320-209-34-2-3 d. Cleaning. There are no special cleaning ing procedures given in Part 1, para 1-3. NOTE Clean all parts before inspection e. Inspection and Repair. FRAME 1 procedures needed. Refer to clean- and before assembly. 1. Check that shafts (1 through 6) have no cracks or distortion. Use magnaflux if available. If shafts are cracked or damaged, get new ones. 2. Check that all machined surfaces and threads are not worn or damaged. If parts are damaged, get new ones. 3. Check that splines on shafts (3 and 6), flanges (7 and 8), and sliding gear (9) are not worn, scored, burred, bent, twisted or rough. Raised metal, nicks or scratches must be taken off with honing stone and shafts polished using crocus cloth. If more repair is needed, get new parts. 4. Check that splines on shafts (3 and 4), flanges (7 and 8), (9) join together and move easily with one another. Minor smoothed with a honing stone, then polished with a crocus repair is needed, get new parts. GO TO FRAME 2 and sliding gear damage can be cloth. If more 18-245