TM 9-2320-209-34-2-3 FRAME 2 NOTE Be sure that shifting rod (1) is meshed in third notch of shifter shaft (2). 1. Place shifting rod (1) in third notch of shifter shaft (2). If needed, screw in shifter shaft until shifting rod catches shaft. 2. Take out cotter pin (3) and loosen nut (4) holding flange (5) on shaft assembly (6). 3. Take out four capscrews (7) and washers (8). 4. Loosen bearing cap (9) from housing (10) by pulling on flange (5). 5. Take out shaft assembly (6). Be careful not to lose or damage shims (11). GO TO FRAME 3 18-231