TM 9-2320-209-34-2-3 FRAME 3 1. Press oil seal assembly (1) and two bearings (2) into front end cover (3). Refer to Part 1, para 10-8. 2. Line up front end cover (3) with drive shaft assembly (4), driven shaft assembly (5), and guide pins (6). 3. Push front end cover (3) onto guide pins (6) and against hoist pump assembly (7). 4. Carefully clamp hoist pump assembly (7) in vise with soft caps, 5. Put in eight screws (8) with lockwashers (9). 6. Tighten screws (8) to 30 to 40 pound-feet. 7. Tap key (10) in slot in drive shaft assembly (4). 8. Take hoist pump assembly (7) out of vise. END OF TASK 18-212