TM 9-2320-209-34-2-3 FRAME 2 Soldier A Soldier B Soldiers A and B 1. Place wooden block, 4 inches x 4 inches x 4 feet, under upper end of two hoist cylinder assemblies (1). 2. Take out two screws with lockwashers (2). Hold lower retainer (3) so that it will not fall when last screw (2) is taken out. Take out upper retainer (4). 3. Take out two screws and lockwashers (5). 4. Take off two bearing caps (6). CAUTION END OF TASK Bypass tubes on outside of hoist cylinder assembly (1) are easily damaged. Be careful when lifting out hoist cylinder assembly. 5. Hold hoist cylinder assembly (1). 6. Using pry bar, pry bottom of hoist cylinder assembly (1) towards rear of truck. 7. Pull piston rod (7) out of crosshead (8) and lift hoist cylinder assembly (1) off truck. 18-192