TM 9-2320-209-34-2-3 18-7. HYDRAULIC HOIST REMOVAL, REPAIR, AND REPLACEMENT (TRUCK M342A2). TOOLS: No special tools required SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Artillery and automotive grease, type GAA, MIL-G-10924 PERSONNEL: Two EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedure. Start engine and raise dump body. Refer to TM9-2320-209-10. b. Removal. FRAME 1 1. Take out lubrication fitting (1). 2. Take out screw (2) and nut (3). 3. Place wood block (4) under ends of two hoist cylinders (5) as shown. 4. Drive out pin (6). 5. Do steps 1, 2, and 4 again for other side of dump body. 6. Start engine and place dump body control in down position to pull back hoist assembly (7). Refer to TM 9-2320-209-10. 7. Slide off roller arm assemblies (8 and 9). GO TO FRAME 2 18-169