TM 9-2320-209-34-2-3 h. Testing. FRAME 1 NOTE Test rear winch mounted on the truck. Use winch control lever on truck to mesh clutch when testing drum clutch and brake. To turn on power to rear winch, refer to operators manual, TM 9-2320-209-10/1. Soldier A Soldier B Soldier A 1. 2. 3. 4. 5. 6. 7. WARNING Always wear leather gloves when handling cable. Other- wise, injury to hand could result. Unwind 10 feet of cable (1), by hand. Turn on power to rear winch. Turn locking latch (2) to the unlocked position. Push control lever (3) forward. Put on locking latch. While soldier B is unlocking latch (2), turn drum (4) by hand. The clutch must mesh. If clutch does not mesh properly, shut down power. Take out drum and shaft assembly (4 and 5). Refer to para 18-5c, frames 11 through 14. Make sure clutch and brake plate spring are put in correctly. Refer to para 18-5f, frames 13 through 15. Assemble drum and shaft assembly (4 and 5). Refer to para 18-5f, frames 16 through 19. Do steps 1 through 6 again. GO TO FRAME 2 18-148