TM 9-2320-209-34-2-3 FRAME 16 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. Turn sleeve (1), until the tapped hole is alined with the groove in brake plate (2). Put in capscrew (3) and washer (4). Be sure that capscrew (3) goes into groove in brake plate (2). Tighten capscrew. Turn sleeve (1) on brake plate (2). Be sure it moves freely. If not, check capscrew (3) installation. Try to turn brake plate (2) on drumshaft (5). If plate turns, take off brake plate and check keys (6) on drumshaft (5). Slide sleeve (1), back and forth on brake plate (2). Sleeve must hold in two positions on clutch detent action. Move sleeve (1) away from flange on brake plate (2). Clutch spring (7) must force brake plate back until plate is locked in position by clutch detents. Move sleeve (1) toward flange on brake plate (2). Brake plate must force spring (7) to squeeze until detents hold plate in this second position. Put further pressure in the same direction on sleeve (1). Sleeve must cause brake plate (2) to squeeze spring (7) another 5/32 inch. Back off pressure on sleeve (1). Spring (7) must force brake plate (2) back until detents hold in the second position. Plate must not snap back to first position. If sleeve (1) and brake plate (2) do not move properly for all of these conditions, check clutch detent installation. GO TO FRAME 17 18-128