TM 9-2320-209-34-2-3 FRAME 8 1. 2. 3. 4. 5. 6. Turn sprocket (2) until stop lug on brake collar (1) is on top. NOTE During the following procedure, the location of the stop lug on brake collar (1) must be known at all times. Press hard on sprocket (2), forcing worm (3) to move as far forward as possible. With stop lug on brake collar (1) on top, thread worm brake (4) onto stud end of worm (3) until the outer face of brake is 3 1/32 inches from the inner face of bearing housing (5). Put tapered end of stop pin (6) into the nearest hole to the left of stop lug on brake collar (1). Tap pin until end of pin is slightly below surface of worm brake (4). Put new gasket (7) and retaining plate (8) on worm brake (4). Put two capscrews (9) and washers (10) on retaining plate (8). GO TO FRAME 9 18-120