TM 9-2320-209-34-2-3 FRAME 5 1. Pack thrust bearings (1 and 2) with type GAA lubricating grease, MIL-G-10924. 2. Put bearing assembly (1) on wormshaft (3). 3. Put washer (4) and shim set (5) on worm shaft (3). NOTE Be sure to use shim set which was fixed for proper clearance in frame 3. 4. Put bearing assembly (2) on wormshaft (3). 5. If oil seal (6) was taken off bearing retainer (7), press new seal into retainer with lip of seal facing inside of retainer. 6. Put retaining plate (8) on bearing retainer (7). 7. Put on four capscrews (9) and washers (10). GO TO FRAME 6 18-117