TM 9-2320-209-34-2-3 CHAPTER 18 WINCH, HOIST, AND POWER TAKEOFF ASSEMBLIES GROUP MAINTENANCE Section I. SCOPE 18-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance procedures for the winch and hoist assemblies, and power takeoff assembly for which there are authorized corrective maintenance tasks at the direct and general support maintenance levels. 18-2. EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective maintenance is authorized at the direct and general support maintenance levels are covered in this chapter. Section II. WINCH AND HOIST ASSEMBLIES 18-3. FRONT WINCH REPAIR. TOOLS: No special tools required SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags Gearcase cover gasket Bearing cap gasket Sliding clutch key (2) Brake case gasket Preformed packing Brake case cover gasket PERSONNEL: TWO EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Remove front winch. Refer to TM 9-2320-209-20. (2) Drain front winch. Refer to LO 9-2320-209-12/1. 18-1