TM 9-2320-209-34-2-2 Section III. FENDERS, RUNNING BOARDS, AND WINDSHIELD ASSEMBLY 17-7. FRONT FENDER REMOVAL, REPAIR, AND REPLACEMENT. NOTE This task is the same for left and right front fenders except as noted. TOOLS: No special tools required SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags PERSONNEL: T Wo EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. stack. Preliminary Procedures. (1) Open hood. Refer to TM 9-2320-209-10. (2) If working on right fender of truck with exhaust stack, remove exhaust Refer to TM 9-2320-209-20. (3) If working on left fender of truck and truck has personnel hot water heater, remove personnel hot water heater, Refer to TM 9-2320–209-20. (4) If working on left fender, and truck has vehicular compartment heater, remove vehicular compartment heater and exhaust tube. Refer to TM 9–2320-209-20. (5) If working on right fender, remove air cleaner intake hood. Refer to TM 9-2320-209-20. (6) If working on right fender and vehicle is equipped with an engine com- partment heater, remove clamp holding heater control wire and push wire out of way. Refer to Hot Water Personnel Heater Blower Motor Repair, TM 9-2320-209-20. (7) If working on right fender, remove hood right side panel. If working on left fender, remove hood left side panel. Refer to TM 9-2320-209-10. 17-79