TM 9-2320-209-34-2-2 17-65. DUMP TRUCK SUBFRAME REMOVAL AND REPLACEMENT. TOOLS: No special tools required SUPPLIES: None PERSONNEL: Two EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Remove dump body. Refer to para 17-68. (2) Remove hydraulic hoist control linkage. Refer to Hydraulic Hoist Control Linkage Removal, Replacement, and Adjustment TM 9-2320-209-20. (3) Remove hydraulic hoist pump drive shaft. Refer to Hydraulic Hoist Pump Drive Shaft Removal, Repair, and Replacement, TM 9-2320-209-20. b. Removal. FRAME 1 1. 2. 3. Take out two screws with self-locking nuts (1). Take off fender with bracket (2). Take out screw with self-locking nut (3). Do steps 1 and 2 again for other rear fender. GO TO FRAME 2 17-763