TM 9-2320-209-34-2-2 FRAME 3 1. Turn wormgear shaft (1) until worm wheel (2) meshes with wormgear in wormgear assembly housing (3). 2. Facing end of worm gear assembly housing (3), check that worm gear in wormgear assembly housing is centered over worm wheel (2). If wormgear is not centered, take out two screws (4) and add or take off a shim (5) until wormgear is centered. Put in two screws. 3. Check that ends of worm gear shaft (1) have no play in them. If ends of shaft have play, set worm adjusting bearing. Refer to para 17-49g. GO TO FRAME 4 17-606