TM 9-2320-209-34-2-2 1. Take off eight screws (1) and lockwashers (2) from retainers (3 and 4). 2. Tap threaded end of gear shaft assembly (5) with soft-faced hammer until puller can be put on retainer (4). 3. Pull off rear retainer (4) and gasket (6). Throw away gasket. 4. Tap unthreaded end of gear shaft assembly (5) to loosen front retainer (3). 5. Pull off front retainer (3), gear shaft assembly (5), and gasket (7) from main drive idler gear housing (8). 6. Pull off retainer (3) and gasket (7) from gear shaft assembly (5) and throw away gasket. NOTE When pulling off retainer (3), bearing may also come off shaft with retainer. GO TO FRAME 5 17-573