TM 9-2320-209-34-2-2 (3) Cleaning, inspection, and repair. WARNING Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when solvent is used. Use only in well- ventilated places. Failure to do this may result in injury to personnel and damage to equipment. (a) Cleaning. Using dry cleaning solvent, clean all parts. Use a stiff brush if needed. After cleaning, use cold water to rinse off any solvent. (b) Inspection. Check that all parts have no cracks, breaks distortion. (c) Repair. Weld any cracks or breaks found in inspection. TM 9-237. Hammer out any bends or dents. Refer to FM 43-2. (4) Assembly. or Refer to 1. Aline shackle (1) and shackle bracket (2). Put shackle pin (3) in place. 2. Put cotter pin (4) in shackle pin (3). END OF TASK 17-422