TM 9-2320-209-34-2-2 17-38. REAR DOOR HINGES REMOVAL AND REPLACEMENT (TRUCKS M109A2 and M109A3). TOOLS: No special tools required SUPPLIES: Rivet (20) PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Remove van door (2) Remove exhaust b. Removal. assembly. Refer blower assembly. to TM 9-2320-209-20. Refer to TM 9-2320-209-20. FRAME 1 1. 2. 3. 4. GO Working at left rear of truck, drive out ten rivet caps (1) along side panel (2). Drill and take out ten rivets (3). Take out 14 screws (4) across top and bottom of panel (2) next to wall (5). Take off panel. Do steps 1 and 2 again for right rear panel. TO FRAME 2 and down side 17-397