TM 9-2320-209-34-2-2 1. Put thin coat of gasket cement to part of head (1) next to casing (2). Place casing on bench, outboard head (3) down. 2. Push inboard head (1) down of liner (5). 3. Put in eight lockwashers (6) If rotor inboard 4. Put in key (8) in GO TO FRAME 6 rotor (4). Turn inboard head to seat pin hole and screws (7). NOTE (4) binds, loosen screws (7) and tap head (1) with hammer. Tighten screws. end of rotor (4). 17-246