TM 9-2320-209-34-2-2 FRAME 3 1. 2. 3. 4. Find punch marks made at time of diassembly. Put liner (1) in casing (2). Be sure pin hole in liner is at top of pump. CAUTION Replacement rotors are bronze with stainless steel shaft. This makes the pump assembly suitable for either fuel or water tank bodies. If rotor is not replaced, look to see if rotor is bronze or cast iron. If rotor is cast iron, put a tag on reading “fuel tank truck only”. Cast iron and water makes rust and can damage pump. Place casing (2) on a bench with outboard head (3) down. Place a pushrod pin (4) in each of the two holes through the rotor (5). Put rotor in pump liner (1). Place casing (2) on bypass valve (6) side, while holding rotor shaft (5) against outboard head (3). Turn rotor (5) by hand. As slot (7) reaches top, put in vanes (8). Be sure beveled edge is against liner (1) and pressure grooves on right side of vane. GO TO FRAME 4 17-244