TM 9-2320-209-34-2-2 c. Cleaning. There are no special cleaning procedures needed. Refer to cleaning procedures given in Part 1, para 1-3. NOTE Clean all parts before inspection and before assembly. d. Inspection and Repair. FRAME 1 1. Check that pin (1) is not bent, cracked or worn. 2. Check that mounting bracket (2), supporting bracket (3), three nuts (4), bracket (5), housing (6) or stop arm (7) have no bends, dents, cracks or damaged threading. 3. Check that 4. Check that 5. If any part END OF TASK ball (8) is not worn or cracked. spring (9) is not broken or distorted. is damaged, get a new part. 17-183