TM 9-2320-209-34-2-2 17-21. TANK BODY DOOR HOLDER REMOVAL, REPAIR, REPLACEMENT, AND ADJUSTMENT. TOOLS: No special tools required SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Cotter pin (3) Rags PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Removal. FRAME 1 NOTE This task is the same for the left and right door holders. This task is shown for the right door holder. 1. Open pump compartment door (1). 2. Take out three screws and washers (2) and take off nuts (3) holding door holder (4) to pump compartment door (1). Block open door. 3. Take out two screws and washers (5) and take off nuts (6) holding door holder (4) to truck frame (7). Take off door holder. END OF TASK 17-180