TM 9-2320-209-34-2-2 There are no special cleaning procedures needed. Refer to cleaning procedures given in Part 1, para 1-3. NOTE Clean all parts before inspection and before assembly. d. Inspection and Repair. FRAME 1 1. Check that all threaded parts are not stripped or crossheaded. If parts are damaged, get new ones. 2. Check that lashing hook (1), latch rods (2), latch guides (3), caution plate (4), and instruction plate (5) are not bent or dented. Straighten bent or dented parts. Refer to FM 43-2. If more repair is needed, get new parts. 3. Check that door latch (6) is not damaged. If door latch is damaged, get a new one. 4. Check that pump compartment door (7) is not bent, dented, torn or cracked. Straighten bends or dents. Refer to FM 43-2. Weld cracks. Refer to TM 9-237. If more repair is needed, get a new part. 5. Check that lock cylinder (8) is not damaged. If part is damaged, get a new one. END OF TASK 17-170