TM 9-2320-209-34-2-2 CHAPTER 17 BODY, CAB, AND HOOD GROUP MAINTENANCE Section I. SCOPE 17-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance procedures for hood and cab components, fenders, running boards, and body com- ponents and special purpose body components for which there are authorized corrective maintenance tasks at the direct and general support maintenance levels. 17-2. EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective maintenance is authorized at the direct and general support maintenance levels are covered in this chapter. Section II. HOOD AND CAB COMPONENTS 17-3. HOOD SIDE PANELS REMOVAL, REPAIR, AND REPLACEMENT. TOOLS: No special tools required SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) If working on right, side hood panel, remove air cleaner, cap, and inlet screen. Refer to TM 9-2320-209-20. (2) Open hood and side panels. Refer to TM 9-2320-209-10. 17-1