TM 9-2320-209-34-2-2 b. Cleaning. WARNING c. Dry cleaning solvent is flammable. Do not use near an open flame. Keep a fire extinguisher nearby when solvent is used. Use only in well- ventilated places. Failure to do this may result in injury to personnel and damage to equipment. (1) Clean part with solvent. (2) If needed, use steam, wire brushes or scrapers to take off grease or gum. Inspection and Repair. (1) Check that fender has no dents, cracks, bends, loose or cracked welds or holes. (2) Fix dents in fender with a peening hammer or rubber mallet. (3) Fix cracks or holes in fender by welding. Refer to TM 9-237. (4) If more repair is needed, get a new part. (5) Paint fender after repair. Refer to TM 43-0139. 17-99