TM 9-2320-209-34-2-1 b. Removal of Bearing from Shaft by Pulling. TOOLS : No special tools required SUPPLIES: None PERSONNEL: One 1. Put puller plate (1) on shaft (2) with bearing (3) as shown. Close puller plate until inner race (4) of bearing (3) rests on puller plate but plate does not touch shaft (2). 2. Tighten two nuts (5) to keep puller plate (1) from opening. 3. Put puller wrench (6) on push-puller (7) as shown. Screw in and tighten two legs (8) into puller plate (1). 4. Pull bearing (3) off shaft (2). END OF TASK 10-100