TM 9-2320-209-34-2-1 Section III. DIFFERENTIAL CARRIER ASSEMBLY 10-7. DIFFERENTIAL CARRIER ASSEMBLY REMOVAL, REPAIR, AND REPLACEMENT. TOOLS: Mechanical puller kit, pn 4231596 Mechanical puller kit, pn 8708724 Handle, pn 7083241 Puller, pn 8366689 (2) Bearing cup replacer, pn 7083252 Oil seal replacer, pn 7083256 Gear replacer, pn 7083257 Oil seal remover, pn 7083250 Bearing remover, pn 7083251 Bearing sleeve remover/replacer, pn 7083246 Hook spanner wrench, pn 7083260 Oil seal remover, pn 7083249 Screw, pn 7083216 SUPPLIES: Differential parts kit Gasket and shim set Bevel gear set Cleaning compound, MIL-C-1109 Oil, MIL-L-17672 Red lead pigment, TT-P-86 Prussian blue, MIL-P-30501 Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Fine lapping stone Safety wire, MS-20995 Gear lubricating oil, GO 80/90, MIL-L-2105 PERSONNEL: TWO EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Front axle differential. (a) Jack up and support truck chassis. rails behind front axle housing. Refer to Jacking and TM 9-2320-209-20. Put safety trestles under frame Supporting Truck Chassis, (b) Drain differential. Refer to LO 9-2320-209-12/1. (c) Remove propeller shaft. Refer to Propeller Shaft and Universal Joint Removal and Replacement, TM 9-2320-209-20. (d) (e) (f) (g) (h) (i) Remove front wheels. Refer to TM 9-2320-209-10. Remove drag link. Refer to TM 9-2320-209-20. Remove brake hydraulic lines. Refer to TM 9-2320-209-20. Remove front axle assembly. Refer to para 10-3. Place axle on axle stand. Remove axle shafts. Refer to TM 9-2320-209-20. 10-41