frame 4 TM 9-2320-209-34-2-1 1. Measure 2. Measure 3. Measure 4. Measure NOTE Readings must be within limits given in table 10-4. If readings are not within given limits, throw away part and get a new one. tooth width of shaft splines (1). diameter of outer shaft journal (2). diameter of inner shaft journal (3). outside diameter for bearing surface on universal joint (4). END OF TASK Index Number 1 2 3 4 Table 10-4. Front Axle Shaft and Universal Joint Wear Limits Size and Fit Wear of New Parts Limits Item/Point of Measurement (inches) (inches) Shaft spline tooth width 0.1704 to 0.1750 0.1699 Outer shaft journal diameter 1.668 to 1.670 1.666 Inner shaft journal diameter 1.668 to 1.670 1.666 Universal joint bearing surface 1.1614 to 1.1618 None 10-34