frame 2 TM 9-2320-209-34-2-1 1. Measure 2. Measure 3. Measure 4. Measure NOTE Readings must be within limits given in table 10-3. The letter L shows a loose fit. If readings are not within given limits, throw part away and get a new one. fit of shaft splines (1) in drive flange (2). diameter of outer shaft journal (3). diameter of inner shaft journal (4). diameter of drive balls (5). NOTE Drive balls (5) are 0.001, 0.002, and 0.003 inch under- size and 0.001, 0.002, and 0.003 inch oversize. END OF TASK Table 10-3. Front Axle Shaft and Ball-type Universal Joint Wear Limits Index Number 1 and 2 3 4 10-32 Size and Fit of New Parts Item/Point of Measurement (inches) Spline shaft fit in drive flange 0.004 L Outer shaft journal diameter 1.667 to 1.670 Wear Limits (inches) 0.010 L 0.005 0.003