TM 9-2320-209-34-2-1 7-10. FLOODLIGHT HARNESS REMOVAL AND REPLACEMENT (TRUCK M756A2). NOTE Refer to removal and replacement procedures given in TM 9-2320-209-20, if needed, to work on con– nectors and electrical leads covered in this task. TOOLS : No special tools required SUPPLIES: 8 gauge wire, 6 feet PERSONNEL: One EQUIPMENT CONDITION : Truck parked, engine off, handbrake set. a. Preliminary Procedure. Remove cab protector. Refer to TM 9-2320-209-20. b. Removal. NOTE Tag all leads so that they are put back in the right place. 1. Unplug four connectors (1) from left and right floodlights. 2. Unplug three connectors (2) from clearance lights. 3. Take off four grommets (3). 4. Put four connectors (1) through two holes and into cab protector. 5. Put three connectors (2) through hole and into cab protector. 6. Put three connectors (4) through hole and into cab protector. 7. Hook floodlight harness and pull it out through top right end of cab protector. END OF TASK 7-33