frame 4 TM 9-2320-209-34-2-1 1. Unplug holes in three fuel injectors (1) and three holes in injector pump head (2). 2. Put three fuel injector tubes (3) in place. Put on three tube nuts (4) and three tube nuts (5). 3. Tighten three tube nuts (5) to 23 to 25 pound-feet. 4. Slide three dust covers (6) into place. 5. Put four clamps (7) in place. Put in four capscrews 6. Put outer clamp (9) in place. Put in two capscrews, self-locking nuts (10). NOTE and nuts (8). flat washers, and Follow-on Maintenance Action Required: 1. Fill cooling system. Refer to TM 9-2320-209-20. 2. Close hood and side panels. Refer to TM 9-2320-209-10. END OF TASK 2-196