TM 9-2320-209-34-2-1 2-15. CAMSHAFT ASSEMBLY REMOVAL AND REPLACEMENT. TOOLS: Mechanical puller kit, pn 8708724 SUPPLIES: Gear cover-to-engine front plate gasket PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. a. Preliminary Procedures. (1) Open hood. Refer to TM 9-2320-209-10. (2) Drain cooling system. Refer to TM 9-2320-209-20. (3) Remove radiator. Refer to TM 9-2320-209-20. (4) Remove fuel filter. Refer to TM 9-2320-209-20. (5) Remove oil filter. Refer to TM 9-2320-209-20. (6) Remove injector lines. Refer to TM 9-2815-210-34. (7) Remove oil cooler. Refer to para 2-18. (8) Remove engine cooling fan. Refer to TM 9-2320-209-20. (9) Remove all drive belts. Refer to TM 9-2320-209-20. (10) Remove air compressor and air compressor bracket. Refer to TM 9-2320-209-20. (11) (12) (13) (14) (15) (16) (17) (18) (19) (20) (21) 2-148 Remove water pump. Refer to TM 9-2320-209-20. Remove tappet chamber cover. Refer to TM 9-2815-210-34. Remove crankcase breather adapter. Refer to TM 9-2815-210-34. Remove rocker arm cover. Refer to TM 9-2815-210-34. Remove rocker arm assembly. Refer to TM 9-2815-210-34. Remove push rods. Refer to para 2-14. Remove valve tappets. Refer to TM 9-2815-210-34. Remove vibration damper and pulley assembly. Refer to para 2-8. Remove tachometer right angle adapter and flexible shaft. Refer to Tachometer Assembly, TM 9-2320-209-20 Remove injector pump drive gear access cover. Refer to para 2-16. Remove oil pan. Refer to TM 9-2815-210-34.