TM 9-2320-209-20-3-4 19-10. FRONT, MID, AND REAR WINCH CABLE AND CHAIN ASSEMBLY REMOVAL, REPAIR, AND REPLACEMENT. NOTE This task shown is for the mid winch cable and chain assembly. This task is the same for the front and rear winch cable and chain assemblies. TOOLS: 3/8-inch socket head screw key Wire cutters (Allen wrench or equivalent) Hammer 12-inch ruller Soft-jawed vise Leather gloves Adjustable wrench (2) SUPPLIES: Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680 Clean rags Clevis assembly Seizing PERSONNEL: One EQUIPMENT CONDITION: Truck parked, engine off, handbrake set. WARNING Always wear protective gloves when handling winch cable. Do not let winch cable slip through hands. Rusty or broken wires can cause serious injury. a. Preliminary Procedure. Unwind winch cable to the end. Refer to TM 9-2320-209-10. 19-48