TM 9-2320-209-20-3-4 FRAME 4 Soldier A Soldier B Soldier A NOTE Some trucks may have speedometer flexible shaft clamped to floorboards instead of accelerator stop bolt. 1. Stand by in cab with 9/16-inch wrench to hold accelerator stop bolt (1) when soldier B is ready under truck. 2. Put clamp (2) on flexible shaft (3). Tell soldier A to press down on stop bolt (1) with fingers. 3. Put clamp (2) on bolt and screw on locknut (4) with fingers. CAUTION Check that flexible shaft (3) is clear of all moving linkages and free of sharp bends. Move shaft in clamp as necessary to feed extra slack through cab floor. 4. Tell soldier A to hold stop bolt (1) with 9/16-inch wrench. Using 9/16-inch wrench, tighten locknut (4). 5. Lower pedal (5) and put connecting link (6) through hole in pedal. Using pliers, put cotter pin (7) through hole in end of connecting link and bend open ends of cotter pin. GO TO FRAME 5 22-28