TM 9-2320-209-20-3-3 FRAME 2 1. 2. 3. 4. 5. Hold roller (1) in place, and put roller shaft (2) through holes in bracket (3) and roller. Put washer (4) on roller shaft. Using 1 ½-inch wrenches, hold roller shaft (2) and screw on and tighten nut (5). Aline a slot in nut with hole in roller shaft. Put cotter pin (6) through slot in nut (5) and hole in roller shaft (2). Using pliers, bend open ends of cotter pin. Using 7/16-inch wrench, screw in and tighten grease fitting (7). Do steps 1 through 4 again for roller (8). NOTE Follow-on Maintenance Action Required: Lubricate roller assemblies. Refer to LO 9-2320-209-12/1. END OF TASK 18-510