TM 9-2320-209-20-3-3 c. Repair. Check all parts. If parts are damaged, get new ones. d. Replacement. (1) Clamp. 1. Hold eyebolt (1) in place and put pin (2) through clamp bracket (3) and eyebolt (1). 2. Hold clamp (4) in place and put pin (5) through clamp (4) . Use hammer to tap pins ( 2 and 5) in 3. Put two cotter pins (6) through holes in pins (2 bend open end of cotter pins. 4. Swing clamp (4) up so eyebolt (1) goes through clamp bracket (3) and place. and 5) . Using pliers, hole in clamp. 5. Put lockwashers (7) and flat washer (8) on eyebolt (1) and screw on wing nut (9) two or three turns. END OF TASK 18-479